It is possible to set the sensor length using a custom command in a label to reset the sensor.If the issue has reached this point, it is suggested that Zebra be contacted for assistance.If the issue is still present after completing the steps outlined above it is possible that the internal sensor setting for the stock size is not correct or is not being reset.The internal stock size calibration for non continuous stock is not being reset Check setting for Label Length and Stock type.Review the Printer's User Guide for information on menu setting within the printer.The settings within the Printer configuration are incorrect Select the Label options and verify the Label Top setting is correct.in design and press F5 (Label Setup and Properties) verify the label size. Open the Label A label is a design area on the computer screen where a label format is created or edited.The stock settings in Loftware is incorrect
#Zebra stock manual#
Calibrate the printer according to the manual calibration sets outlined in the Printer's Users Guide.Resolve the issue by using the following recommended procedures: The printer needs to be calibrated for the new Stock size The internal stock size calibration for non continuous stock is not being reset.The settings within the Printer configuration are incorrect.The stock settings in Loftware is incorrect.The printer needs to be calibrated for the new Stock size.The next label output only prints 6 inches of the label and not the full 10 inches. For example: a Zebra printer was used to print 4 x 6 labels and a change was made for a new label that uses 4 x 10 stock. When the new label is printed, only part of the label is printed. ExplanationĪ stock size change is not being recognized by the printer. After modifying the stock size, the printer is still printing the label as if the stock was the former size. Stock size change is not being applied to the target Zebra printer.
0 kommentar(er)
